1/2 HP REBUILT MILK TRANSFER PUMP with intake hose and fittings
For Low volume applications such as small milking systems or transferring 100 gallon or less at one time
1.5 TRICLAMP IN
1.5 TRICLAMP EXIT.
EASY TO WASH AND ASSEMBLE. TRANSFER PUMP IN SMALL PROCESSING PLANTS.
- used Stainless Steel pump body and 4 blade impeller
- new 1/2 hp 230 volt painted motor 1 phase (3 phase motor available)
- new MPK11 seal kit installed
- new 1.5 foot HD intake hose with clamp fitting on pump end and bevel seat fitting on milk tank end
- new hose adaptor for outlet side. (this fitting is available for hose sizes 5/8, 3/4, 1 or 1.5 inch ID)
- new HD clamps and silicone gaskets
- new spare parts include 1 xtra seal kit and 2 silicone flange gaskets
Required but not included
- wiring and electrical switch.
Installation by a qualified electrician recommended.
Pump motor must grounded before operating.
- outlet hose (Hose ID and length needed to determine what hose to order)
1090-005 - 5/8 inch ID hose
1090-008 - 3/4 inch ID hose
1090-010 - 1 inch ID hose
- 1407 pump stand. Depending on the height of your product tank valve, you may want a stand to raise up the pump or you can request a longer intake hose when ordering.
MPK11 - Replacement seal kit
21575 1 HP Stainless Steel Motor with threaded shaft
21586 1 HP Painted motor with threaded shaft
21585 3/4 HP Painted motor with threaded shaft
21584 1/2 HP Painted motor with threaded shaft
10185 1 HP pump with painted motor
10186 1 HP pump with stainless steel motor
1406 New 1 hp transfer pump with hoses and fittings
1405 Rebuilt 1/2 hp transfer pump with hoses and fittings
1407 Stainless Steel Stand for milk pump
old part number 501-RSSMTP-1/2